Sello del vástago del pistón del anillo Glyd SPGO
SPGO Glyd Ring Piston Rod Seal Information
SPGO is A double-acting O-Ring energized seal developed for sealing between two media such as fluid and gas. It incorporates a limited footprint quad-ring Seal inset into the dynamic sealing face. Installed in grooves. Applied to mobile hydraulics, holding cylinders, piston accumulators, etc.
It combines the characteristics of low friction, high pressure, and high-speed seals, as well as the excellent sealing of rubber elastomers. Therefore, it is suitable for working at high speeds, high pressures, and under pressure.
It can be used as a double-acting piston accumulator to control and guide the cylinder sealing elements. Suitable for machine tools, presses, rolling mills, accumulators, and lifting cylinders.
Recommended for certain heavy-duty and large-diameter applications.
Características
-Low friction and high elasticity, double guarantee
-High sealing effect in fluid/fluid or fluid/gas
-Low gas permeability
-Excellent sliding properties, no stick-slip behavior
-Can be used under high-pressure conditions, with good sliding performance
-Simple groove design
-Simple installation
PTFE+NBR/FKM
Descripción del material | Bronce relleno de PTFE, fibra de carbono y MoS2 rellenos de PTFE, grafito relleno de PTFE, PI relleno de PTFE, relleno de PTFE |
Ekonol and so on. | |
Colores disponibles | Negro, verde, café, blanco, rojo, azul, dorado, etc. |
Resistencia del material | High precision, excellent wear resistance, good self-lubricating performance, environmental protection. |
Temperatura | -45~+200℃ |
Velocidad | ≤3m/s |
Presión | ≤60 MPa |
Medio | Mineral oil based hydraulic fluids,barely flammable hydraulic fluids,water,air and others. |
Dispositivo aplicado | Mobile hydraulics / Holding cylinders/Piston accumulators, etc. |
Datos técnicos | ||||
Presión | Temperatura | Velocidad de deslizamiento | Medio | |
Estándar | ≤60 MPa | -45~+200 ℃ | ≤3 m/s | Ineral oil based hydraulic fluids,barely flammable hydraulic fluids, water,air and others. |
Material | ||||
O ring & X ring | Anillo deslizante | |||
Estándar | NBR | PTFE-Bronce | ||
Special(on request) | FKM | PTFE-Carbono | ||
Presión | 160 bares | 200bar | 300bar | |
Max Gap E | E≤0,6 mm | E≤0,4 mm | E≤0.3mm |